ANSI/ASTM D3826-1998 用张力测定可降解的聚烯烃中降解末端点的实施规程

标准号：ANSI/ASTM D3826-1998
中文标准名称：用张力测定可降解的聚烯烃中降解末端点的实施规程
英文标准名称：Practice for Determining Degradation End Point in Degradable Polyolefins Using a Tensile
标准类型：G31
发布日期：1999/12/31 12:00:00
实施日期：1998/8/17 12:00:00
中国标准分类号：G31
国际标准分类号：83.080.20
适用范围：This practice covers the determination of a degradation-end point (a brittle point) for degradable polyethylene/polypropylene films and sheeting less than 1.0 mm (0.04 in.) thick. This practice is not intended for determination of the rate of degree of degradation of a polyethylene/polypropylene film or sheet, but rather, to assess when in the course of its degradation under some condition, a brittle point is reached. If one wishes to monitor tensile elongation during the degradation process (such as when the tensile elongation is significantly greater than 5 %), Test Method D 882 is recommended. This practice should not be considered the only way of determining a degradation-end point. Tensile properties of plastics 1.0 mm (0.04 in.) or greater in thickness shall be determined in accordance with Test Method D 638. Use a static weighing-constant rate of grip separation test. This procedure employs a constant rate of separation of the grips holding the sample and a static load cell. Note 1 -This procedure is based on the use of grip separation as a measure of extension; however, the desirability of using extension indicators accurate to ?1.0 % or better as specified in Test Method D 638 is recognized, and a provision for the use of such instrumentation is incorporated in the procedure. This procedure has been successful for determining the degradation end point of ethylene-carbon-monoxide copolymers and has screened successfully two other additive-type polyethylenes in a round robin test. The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.7 There is no equivalent ISO standard.