ANSI/ASTM D5677-2005 用于航空喷气机涡轮燃料的玻璃纤维(玻璃纤维加固热硬化树脂)管与管件规范.粘合剂粘接接头型

标准号：ANSI/ASTM D5677-2005
中文标准名称：用于航空喷气机涡轮燃料的玻璃纤维(玻璃纤维加固热硬化树脂)管与管件规范.粘合剂粘接接头型
英文标准名称：Specification for Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Pipe Fittings, Adhesive Bonded Joint Type, for Aviation Jet Turbine Fuel Lines
标准类型：E34
发布日期：2005/11/29 12:00:00
实施日期：2005/11/29 12:00:00
中国标准分类号：E34
国际标准分类号：23.040.20;23.040.45
适用范围：This specification covers a reinforced plastic pipe and fittings system made from epoxy resin and glass-fiber reinforcement, together with adhesive for joint assembly, intended for service up to 150F (65.6C) and 150-psig (1034-kPa) operating pressure and surges up to 275 psig (1896 kPa) in aviation jet turbine fuel lines installed below ground. The dimensionless designator NPS has been substituted in this specification for such traditional terms as nominal diameter, size, and nominal size. The values stated in inch-pound units are to be regarded as standard. The values in parentheses are for information only. The following safety hazards caveat pertains only to the test method portion, Section , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1There is no similar or equivalent ISO standard.