BS EN 50065-2-1-2003 频率范围为3 KHz至148.5 KHz的低压电气设备的信号传输.住户,商业和轻工用工作频率范围为95 kHz-148.5 kHz的主要通讯设备和系统的抗扰度

标准号：BS EN 50065-2-1-2003
中文标准名称：频率范围为3 KHz至148.5 KHz的低压电气设备的信号传输.住户,商业和轻工用工作频率范围为95 kHz-148.5 kHz的主要通讯设备和系统的抗扰度要求
英文标准名称：Signalling on low-voltage electrical installations in the frequency range 3 kHz to 148,5 kHz. Immunity requirements for mains communications equipment and systems operating in the range of frequencies 95 kHz to 148,5 kHz and intended for use in residentia
标准类型：M30
发布日期：2003/4/11 12:00:00
实施日期：2003/4/11 12:00:00
中国标准分类号：M30
国际标准分类号：33.040.30;33.100.20
适用范围：This standard applies to electrical equipment using signals in the frequency range 95 kHz to 148,5 kHz to transmit or receive information on low voltage electrical systems, residential, commercial and light industrial environments. In the case of equipment which includes functions other than the transmission or reception of information on low voltage electrical supplies, this standard applies only to that part of the equipment intended for such transmission or reception of information. Other parts of the equipment shall comply with the immunity standard or standards relevant to the functions of those other parts. In the event of tests being specified in those other standards of a different severity and where the construction of the equipment is such that the functions cannot be tested separately, the higher severity shall apply to all affected functions. The object of this standard is to limit mutual influence between mains communication equipment and systems (MCES) operating in different frequency bands as defined in EN 50065-1 and to contribute to ensuring Electromagnetic Compatibility in general. It specifies essential immunity requirements and test methods, including those tests which are to be performed during type-testing of MCES on low-voltage installations, for electromagnetic interference in general and more specific interference coming from other MCES. It therefore defines the immunity test requirements for apparatus in relation to continuous and transient disturbances, both conducted and radiated, and electrostatic discharges. Test requirements are specified for each port considered. This standard gives limits which are applicable to products operating in residential, commercial and light industrial environments. The levels do not however cover extreme cases which may occur in any location but with a low probability of occurrence. In special cases situations will arise where the level of disturbances may exceed the levels specified in this standard e.g. where a hand-held transmitter is used in proximity to an apparatus. In these instances special mitigation measures may have to be employed. It does not specify immunity between mains communication systems operating in the same band (as defined in EN 50065-1) or immunity to signals originating from Power Line Carrier systems operating on high or medium voltage networks. Safety considerations are not included in this standard.