BS EN 13203-3-2010 燃气家用产热水器.不超过70 kW热输入的器具和500 l水存储容器.能量消耗评定

标准号：BS EN 13203-3-2010
中文标准名称：燃气家用产热水器.不超过70 kW热输入的器具和500 l水存储容器.能量消耗评定
英文标准名称：Solar supported gas-fired domestic appliances producing hot water.Appliances not exceeding 70 kW heat input and 500 litres water storage capacity. Part 3: Assessment of energy consumption
标准类型：Q83
发布日期：2010/8/31 12:00:00
实施日期：2010/8/31 12:00:00
中国标准分类号：Q83
国际标准分类号：91.140.65
适用范围：This European Standard is applicable to solar supported gas-fired appliances producing domestic hot water. Itapplies to a system marketed as single unit or a system fully specified by a manufacturer that:? has a gas heat input not exceeding 70 kW; and? has a hot water storage capacity not exceeding 500 l; and? is equipped with at least one solar collector; and? is, with regard to the solar hydraulic circuit, considered as a forced circulation system (definition accordingto EN ISO 9488:1999).The appliances covered by this European Standard are described in Annex C.This European Standard does not apply to thermo-siphon or integral collector storage systems (definitionsaccording to EN ISO 9488-1999).NOTE In principle, the energy consumption of thermo-siphon solar preheat systems and integral collector storagepreheat systems can also be assessed on the basis of this standard. One appropriate procedure for that purpose is tocalculate the temperature level of the domestic hot water withdrawn from the thermal solar system for the referenceconditions defined in this standard by using the numerical system model and the thermal solar system performanceparameters according to ISO 9459-5. Based on the temperature level of the hot water withdrawn from the store the energyconsumption of the gas appliance should be determined. This determination can either be done by means of calculationsor by performing a test according to EN 13203-2 and using instead of the cold water inlet temperature the hot watertemperature withdrawn from the store.This standard is not intended to assess the performance:? of the solar collector(s), which should comply with EN 12975-1 and EN 12975-2; and? thermal solar systems and components, which should comply with EN 12976-1 and EN 12976-2.This European Standard, EN 13203-3, sets out a method for assessing the energy performance of a solarsupported appliance. It defines a number of daily tapping cycles for each domestic hot water use, kitchen,shower, bath and a combination of these, together with corresponding test procedures including informationabout the available solar radiation. It enables the energy performances of different gas-fired appliances to becompared and matched to the needs of the user.