BS EN 61347-2-10-2001+A1-2009 灯的控制装置.冷启动管状放电灯（氖管）的高频操作用电子逆变器和变流器的详细要求

标准号：BS EN 61347-2-10-2001+A1-2009
中文标准名称：灯的控制装置.冷启动管状放电灯（氖管）的高频操作用电子逆变器和变流器的详细要求
英文标准名称：Lamp controlgear - Particular requirements for electronic invertors and convertors for high-frequency operation of cold tubular discharge lamps (neon tubes)
标准类型：K74
发布日期：2001/5/15 12:00:00
实施日期：2001/5/15 12:00:00
中国标准分类号：K74
国际标准分类号：29.140.99
适用范围：This part of IEC 61347 specifies particular requirements for electronic invertors andconvertors for high-frequency operation of tubular cold-cathode discharge lamps used insigns and luminous discharge tube installations and operating with an output voltageexceeding 1 000 V but not exceeding 10 000 V for direct connection to supply voltages notexceeding 1 000 V at 50 Hz or 60 Hz or 1 000 V d.c.NOTE 1 In Japan, the output voltage of 15 000 V is acceptable.The requirements for two types of invertors and convertors, types A and B, are specified asfollows:– Type A unit: an invertor or convertor operating within the frequency range 20 kHz to50 kHz, and having an output voltage (between terminals) not exceeding 5 000 V peak, amaximum output current limited to 35 mA (r.m.s.) and 50 mA (peak value). The supplyvoltage does not exceed 250 V at 50 Hz or 60 Hz or 250 V d.c.NOTE 2 The output current of a type A unit may be considered as not presenting an electric shock hazard due tothe limits on the current and frequency range.NOTE 3 In Japan, the output voltage of 15 000 V is acceptable.– Type B unit: an invertor or convertor having a no-load output voltage not exceeding5 000 V to earth or 10 000 V between terminals, operating within the frequency range10 kHz to 100 kHz with a maximum output current limited to 200 mA (r.m.s.) and 400 mA(peak value).NOTE 4 Type B units require additional protection in the output circuit.NOTE 5 In Japan, a type B unit exceeding 50 mA and/or the secondary grounded is not acceptable.In order to check the safety of invertors or convertors, it is necessary to check theirperformance. However, since no standardization of the characteristics of neon tubes exists,reference loads are specified in this standard to ensure reproducible test results.The rated maximum operating temperature of the winding, tw, is not applicable to thisstandard.