IEC 60238 Edition 8.1-2008 圆螺纹灯座

标准号：IEC 60238 Edition 8.1-2008
中文标准名称：圆螺纹灯座
英文标准名称：Edison screw lampholders
标准类型：K74
发布日期：1999/12/31 12:00:00
实施日期：1999/12/31 12:00:00
中国标准分类号：K74
国际标准分类号：29.140.10
引用标准：IEC 60061;IEC 60061-1;IEC 60061-2;IEC 60061-3;IEC 60068-2-20-1979;IEC 60068-2-32-1975;IEC 60068-2-75-1997;IEC 60112-1979;IEC 60227;IEC 60245;IEC 60335-1-2001;IEC 60352-1-1997;IEC 60399;IEC 60417-DB-2002;IEC 60529-1989;IEC 60598;IEC 60598-1;IEC 60664-1-199
适用范围：This International Standard applies to lampholders with Edison thread E14, E27 and E40,designed for connection to the supply of lamps and semi-luminaires* only.It also applies to switched-lampholders for use in a.c. circuits only, where the working voltagedoes not exceed 250 V r.m.s.This standard also applies to lampholders with Edison thread E5 designed for connection to thesupply mains of series connected lamps, with a working voltage not exceeding 25 V, to be usedindoors, and to lampholders with Edison thread El0 designed for connection to the supplymains of series connected lamps, with a working voltage not exceeding 60 V, to be usedindoors or outdoors. It also applies to lampholders El0 for building-in, for the connection ofsingle lamps to the supply. These lampholders are not intended for retail sale.As far as it reasonably applies, this standard also covers lampholders other than lampholderswith Edison thread designed for connection of series-connected lamps to the supply.NOTE This type of lampholder is for example used in Christmas tree lighting chains.As far as it reasonably applies, this standard also covers adapters.This standard also covers lampholders which are, wholly or partly, integral with a luminaire orintended to be built into appliances. It covers the requirements for the lampholder only. For allother requirements, such as protection against electric shock in the area of the terminals or ofthe lamp cap, the requirements of the relevant appliance standard shall be observed andtested after building into the appropriate equipment, when that equipment is tested according toits own standard. Such lampholders as well as lampholders provided with a snap-on outershell, for use by luminaire manufacturers only, are not for retail sale.This standard applies to lampholders to be used indoors or outdoors in residential as well as inindustrial lighting installations. It also applies to candle lampholders. In locations where specialconditions prevail, as for street lighting, on board ships, in vehicles and in hazardous locations,e.g. where explosions are liable to occur, special constructions may be required.NOTE 1 This standard does not apply to three-light lampholders E26d.NOTE 2 This standard is based on the following data relative to lamps for general lighting service:- caps E14 are used for lamps with a current not exceeding 2 A;- caps E27 are used for lamps with a current not exceeding 4 A;- caps E40 are used for lamps with a current not exceeding 16 A.NOTE 3 If the nominal voltage of the supply does not exceed 130 V, the maximum current for caps E4O is 32 A(see 4.5 and 5.3).NOTE 4 Where lampholders are used in luminaires, their maximum operating temperatures are specified inIEC 60598.