BS PD CEN/TR 15858-2009 建筑产品.基于WT、WFT/FT程序的对建筑产品的受管制危险物质的释放的评估

标准号：BS PD CEN/TR 15858-2009
中文标准名称：建筑产品.基于WT、WFT/FT程序的对建筑产品的受管制危险物质的释放的评估
英文标准名称：Construction products — Assessment of the release of regulated dangerous substances from construction products based on the WT, WFT/FT procedures
标准类型：Q10
发布日期：2009/4/30 12:00:00
实施日期：2009/4/30 12:00:00
中国标准分类号：Q10
国际标准分类号：91.100.01
适用范围：This CEN Technical Report describes a procedure for assessing construction products with regards to theirrelease/emission of regulated dangerous substances (RDS) into the environment in accordance with EssentialRequirement Number 3 of the Construction Products Directive (CPD), as far as these construction productsfall under the responsibility of CEN.NOTE 1 For the purpose of this document and mandate M/366, the release of regulated dangerous substances fromconstruction products is limited to two main environmental compartments:1) soil, groundwater and surface water;2) indoor air.NOTE 2 It should be noted that construction products falling under the CPD and these environmental compartmentsare the subject of other European Union regulations, e.g. REACH, and they may also be the subject of Member Stateregulations.This Technical Report defines how the mandated characteristics expressed in terms of mandated RDSs foreach construction product can be assessed by an individual manufacturer using the ‘Without Testing’ (WT)procedure and/or the ‘Without Further Testing’ (WFT) and ‘Further Testing’ (FT) procedures after an initialtype assessment and how the corresponding information accompanying the CE marking can be expressed interms of declared values or RDS classes.This report describes:a) under which conditions a RDS class for a construction product may be declared by the individualmanufacturer using the ‘Without Testing (WT)’ assessment procedure;b) if all relevant mandated RDSs are assessed by this Without Testing procedure, how a set of RDS classesfor a construction product may also be declared by the manufacturer without the need for testing of theirspecific products;c) how to establish RDS classes for a construction product using a Without Further Testing procedure oncesufficient information has been obtained from initial type testing;d) when and how to undertake Further Testing as part of factory production control;e) how to evaluate conformity of the construction product to one or more RDS classes;f) how to create and declare a set of RDS classes using one or a combination of the WT, WFT and FTprocedures.For construction products that have to be tested, horizontal European release/emission test methods are thereference methods, but this report also describes under which conditions screening tests may be used. Theuse of alternative tests is part of the standard CPD procedure and therefore the use of alternative tests is not described in this report.NOTE A manufacturer is free to use an alternative test calibrated against the reference method. However, databased on the reference method has precedence if there is conflicting information.The procedures described in this CEN Technical Report are intended to be applied for placing products on themarket; it includes the 'no performance determined' option (NPD) for application where compliance to aregulation related to ER 3 of the CPD is not required.This report does not cover European Technical Approvals.This CEN Technical Report is limited to the scope of the CPD and mandate M/366. Consequently,release/emission during the construction and end-of-life phases are not covered.