BS EN ISO 286-2-2010 几何制品规范(GPS).线性尺寸公差的ISO编码系统.孔和轴的标准公差等级和极限偏差表

标准号：BS EN ISO 286-2-2010
中文标准名称：几何制品规范(GPS).线性尺寸公差的ISO编码系统.孔和轴的标准公差等级和*限偏差表
英文标准名称：Geometrical product specifications (GPS) - ISO code system for tolerances on linear sizes - Tables of standard tolerance classes and limit deviations for holes and shafts
标准类型：J04
发布日期：1990/1/31 12:00:00
实施日期：1990/1/31 12:00:00
中国标准分类号：J04
国际标准分类号：17.040.10;17.040.30
引用标准：ISO 286-1-2010
适用范围：This part of ISO 286 gives values of the limit deviations for commonly used tolerance classes for holes andshafts calculated from the tables given in ISO 286-1. This part of ISO 286 covers values for the upper limitdeviations ES (for holes) and es (for shafts), and the lower limit deviations EI (for holes) and ei (for shafts)(see Figures 1 and 2).The ISO system for tolerances on linear size provides a system of tolerances and deviations suitable forfeatures of the following types:a) cylinders;b) two parallel opposite surfaces.For simplicity, and also because of the importance of cylindrical workpieces of circular section, only these arereferred to explicitly. It should be clearly understood, however, that the tolerances and deviations given in thispart of ISO 286 equally apply to workpieces of other than circular sections.In particular, the term “hole” or “shaft” is used to designate features of the cylinder type (e.g. for thetolerancing of the diameter of a hole or shaft) and, for simplicity, these terms are also used for two parallelopposite surfaces (e.g. for the tolerancing of the thickness of a key or the width of a slot).For further information on terminology, symbols, the basis of the system, etc., see ISO 286-1.