ISO 10467-2004 压力和无压力排水和排污塑料管道系统.基于不饱和聚酯树脂的玻璃增强热固性塑料(GRP)系统

标准号：ISO 10467-2004
中文标准名称：压力和无压力排水和排污塑料管道系统.基于不饱和聚酯树脂的玻璃增强热固性塑料(GRP)系统
英文标准名称：Plastics piping systems for pressure and non-pressure drainage and sewerage - Glass-reinforced thermosetting plastics (GRP) systems based on unsaturated polyester (UP) resin
标准类型：G31
发布日期：1999/12/31 12:00:00
实施日期：1999/12/31 12:00:00
中国标准分类号：G31
国际标准分类号：83.140.30;93.030;91.140.80
适用范围：This International Standard specifies the properties of piping system components made from glass-reinforcedthermosetting plastics (GRP) based on unsaturated polyester resin (UP) for drainage or sewerage with orwithout pressure, as well as the properties of the system itself.This International Standard is applicable to GRP-UP piping systems, with flexible or rigid joints with or withoutend thrust load-bearing capability, primarily intended for use in buried installations.NOTE Piping systems conforming to this International Standard can also be used for non-buried applicationsprovided the influence of the environment and the supports are considered in the design of the pipes, fittings and joints.This International Standard is applicable to pipes, fittings and their joints of nominal sizes from DN 50 toDN 4000 which are intended to be used for the conveyance of drainage or sewerage at temperatures up to50 °C, with or without pressure. In a pipework system, pipes and fittings of different nominal pressure andstiffness ratings may be used together.Clause 4 specifies the general aspects of GRP-UP piping systems intended to be used in the field of drainageor sewerage with or without pressure.Clause 5 specifies the characteristics of pipes made from GRP-UP with or without aggregates and/or fillers.The pipes may have a thermoplastics or thermosetting resin liner. Clause 5 also specifies the test parametersfor the test methods referred to in this International Standard.Clause 6 specifies the characteristics of fittings made from GRP-UP, with or without a thermoplastics orthermosetting resin liner, intended to be used in the field of drainage or sewerage. Clause 6 specifies thedimensional and performance requirements for bends, branches, reducers, saddles and flanged adaptors.Clause 6 is applicable to fittings made using any of the following techniques:a) fabrication from straight pipes;b) moulding by1) filament winding,2) tape winding,3) contact moulding,4) hot or cold compression moulding.