BS EN 61290-3-1-2003 光学纤维放大器.基础规范.噪音数字参数的测试方法.光谱分析仪法

标准号：BS EN 61290-3-1-2003
中文标准名称：光学纤维放大器.基础规范.噪音数字参数的测试方法.光谱分析仪法
英文标准名称：Optical amplifiers - Test methods - Part 3-1:Noise figure parameters - Optical spectrum analyzer method
标准类型：M33
发布日期：2004/1/16 12:00:00
实施日期：2004/1/16 12:00:00
中国标准分类号：M33
国际标准分类号：33.180.30
适用范围：This part of IEC 61290 applies to commercially available optical amplifiers (OAs) such as optical fibre amplifiers (OFAs), semiconductor optical amplifiers (SOAs) and planar waveguide amplifiers (PWOAs) as classified in IEC 61292-3. The object of this standard is to establish uniform requirements for accurate and reliable measurements, by means of the optical spectrum analyzer (OSA) test method, of the following OA parameters, as defined in IEC 61291 -1: a) signal-spontaneous noise figure; b) forward amplified spontaneous emission (ASE) power level. The methods described in this part of IEC 61290 apply to single-channel stimulus only. Two alternatives for determining the signal-spontaneous beat noise are possible, namely the ASE direct interpolation technique (Dl) and the polarization nulling with interpolation technique (PN). The accuracy of the Dl technique will suffer when the slope of the OA spectral ASE curve has large wavelength dependence, as in the case of an OA with an internal narrowband ASE suppressing filter. The accuracy of the Dl technique degrades at high input power level due to the spontaneous emission from the laser source(s). Annex A provides guidance on the limits of this technique for high input power. NOTE 1 All numerical values marked with ( ) are suggested values for which the measurement is assured. Other values may be acceptable but should be verified. NOTE 2 General aspects of noise figure test methods are reported in IEC 61290-3.