BS EN 13598-1-2010 无压力地下排水和排污用塑料管道系统.未增塑聚氯乙烯(PVC-U),聚丙烯(PP)和聚乙烯(PE).包括浅层检验室在内的辅助配件规范

标准号：BS EN 13598-1-2010
中文标准名称：无压力地下排水和排污用塑料管道系统.未增塑聚氯乙烯(PVC-U),聚丙烯(PP)和聚乙烯(PE).包括浅层检验室在内的辅助配件规范
英文标准名称：Plastics piping systems for non-pressure underground drainage and sewerage. Unplasticized poly(vinyl chloride) (PVC-U), polypropylene (PP) and polyethylene (PE). Specifications for ancillary fittings including shallow inspection chambers
标准类型：Q81
发布日期：2011/3/31 12:00:00
实施日期：2011/3/31 12:00:00
中国标准分类号：Q81
国际标准分类号：93.030
适用范围：This European Standard specifies the definitions and requirements for ancillary fittings of unplasticized poly(vinylchloride) (PVC-U), polypropylene (PP), and polyethylene (PE) intended to be used in non-pressure undergrounddrainage and sewerage systems, conforming to EN 476:a) outside the building structure (application area code “U”), reflected in the marking of products by “U”, andb) both buried in ground within the building structure (application area code “D”) and outside the building structure(application area code “U”), reflected in the marking of products by “UD”.It also specifies the test parameters for the test methods referred in this standard.The ancillary fittings covered by this standard are the following:? sealed access fittings;? rodding point covers;? rodding tees;? mechanical saddles;? inspection chambers for shallow non-roadway applications to a maximum depth of 1,25 m.NOTE 1 Inspection chambers as defined in 6.1.3 of EN 476:1997 have a riser with a DN/ID less than 800 mm.NOTE 2 Deep inspection chambers and manholes for application area U are specified in Part 2 of this standard.The fittings can be manufactured by various methods e.g. injection moulding, rotational moulding, spiral winding orfabricated from components made to other standards.The jointing can be with:? elastomeric ring seal joint;? cemented joint for PVC-U;? welded joint for PP and PE.NOTE 3 Pipes, fittings and other components conforming to any of the plastics products standards listed in Clause 2 can beused with ancillary fittings conforming to this standard, provided they conform to the requirements for joint dimensions given inClause 6 and to the requirements of Table 6.