BS EN 50131-1-2006+A1-2009 警报系统.闯入和拦截系统.第1部分:系统要求

标准号：BS EN 50131-1-2006+A1-2009
中文标准名称：警报系统.闯入和拦截系统.第1部分:系统要求
英文标准名称：Alarm systems — Intrusion and hold-up systems — Part 1: System requirements
标准类型：A91
发布日期：2006/11/30 12:00:00
实施日期：2006/11/30 12:00:00
中国标准分类号：A91
国际标准分类号：13.320
引用标准：CLC/TS 50131-7-2003;EN 50130-4-1995;EN 50130-5-1998;EN 50131-6-1997;EN 50136-1-1-1998;EN 60065-2002;EN 60073-2002;EN 60950-1-2006;EN 61000-6-3-2007
适用范围：This European Standard specifies the requirements for Intrusion and Hold-up Alarm Systems installed inbuildings using specific or non-specific wired interconnections or wire-free interconnections. Theserequirements also apply to the components of an I&HAS installed in a building which are normally mountedon the external structure of a building e.g. ancillary control equipment or warning devices. The standard doesnot include requirements for exterior I&HAS.This standard specifies performance requirements for installed I&HAS but does not include requirements fordesign, planning, installation, operation or maintenance.These requirements also apply to I&HAS sharing means of detection, triggering, interconnection, control,communication and power supplies with other applications. The functioning of an I&HAS shall not beadversely influenced by other applications.Requirements are specified for I&HAS components where the relevant environment is classified. Thisclassification describes the environment in which an I&HAS component may be expected to functi onas designed. When the requirements of the four environmental classes are inadequate, due to the extremeconditions experienced in certain geographic locations, special national conditions are given in Annex A.General environmental requirements for I&HAS components are described in Clause 7.The requirements of this European Standard also apply to IAS and HAS when these systems are installedindependently.When an I&HAS does not include functions relating to the detection of intruders, the requirements relating tointrusion detection do not apply.When an I&HAS does not include functions relating to hold-up, the requirements relating to hold-up do notapply.NOTE Unless otherwise stated the abbreviation I&HAS is intended to also mean IAS and HAS.