ISO 8502-2-2005 涂覆油漆和相关产品前钢材衬底的预处理.表面清洁度的评定试验.第2部分:洁净表面氯化物的测定

标准号：ISO 8502-2-2005
中文标准名称：涂覆油漆和相关产品前钢材衬底的预处理.表面清洁度的评定试验.第2部分:洁净表面氯化物的测定
英文标准名称：Preparation of steel substrates before application of paints and related products - Tests for the assessment of surface cleanliness - Part 2: Laboratory determination of chloride on cleaned surfaces
标准类型：A29
发布日期：1999/12/31 12:00:00
实施日期：1999/12/31 12:00:00
中国标准分类号：A29
国际标准分类号：25.220.10
适用范围：This part of ISO 8502 describes a method for the determination of chloride-containing salts that are readily soluble in water and are present on a steel surface. The method is also applicable to previously coated surfaces. It will normally be used in a laboratory using washings sampled from surfaces on site. The method is applicable to the determination of salts that have been deposited on the steel surface before, during or after the cleaning operations. NOTE 1 Although the procedure for chloride determination is generally accurate, the overall precision of the method is limited by uncertainties in the sampling procedure. In addition, traces of iron chloride at the bottom of pits are difficult to extract into the sample. The test method is not applicable to surfaces treated with chromate, nitrite or amine, which are commonly used as inhibitors in the water when wet blast-cleaning. This is because a chromate concentration of 10 mg/l or greater or a nitrite concentration of 20 mg/l or greater in the wash water interferes with the determination of the chloride. Also the amine inhibitors can form a hydroxide boundary layer (not water soluble) over the substrate and prevent the water from contacting the underlying salt for its removal. An iron(lll) ion concentration of 10 mg/l also interferes with the determination, but the iron(lll) ions are concentrated in the rust deposits, which are removed from the test solution by filtration. NOTE 2 The performance of a paint system is affected by the amount of soluble chloride remaining on the surface. The acceptable level of this contamination is related to the service conditions. For further information regarding levels of water-soluble salt contamination see ISO/TR 15235