ANSI/ASTM D5650-1997 在0-10 Taber硬挺度单位扩展范围内使用Taber型硬挺度试验仪的试验方法

标准号：ANSI/ASTM D5650-1997
中文标准名称：在0-10 Taber硬挺度单位扩展范围内使用Taber型硬挺度试验仪的试验方法
英文标准名称：Test Method for Use of the Taber-Type Tester for Stiffness in the Expanded 0-10 Taber Stiffness Unit Range
标准类型：N74
发布日期：1999/12/31 12:00:00
实施日期：1999/12/31 12:00:00
中国标准分类号：N74
国际标准分类号：85.060
适用范围： This test method covers a procedure used to measure the resistance to bending of papers which are of low grammage or high flexibility, or both, and which exhibit bending stiffness in the range from 0 to 10 Taber stiffness units. The bending moment required to deflect the free end of a 38-mm (1.5-in.) wide vertically clamped specimen 15? from its center line when the load is applied 10 mm (0.39 in.) away from the clamp is determined. The resistance to bending is calculated from the bending moment. The instrument used in this test method is identical to that described in Test Method D 5342, used in the modified configuration described in Section 9. Test results obtained using the Taber-Type tester as described in this test method have been reported to be as much as 40 % different from those obtained using Test Method D 5342, and this test method shall not be used where Test Method D 5342 is specified. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.