ANSI/ASTM D6272-2000 利用四点结合法进行非增强和增强塑料及电气绝缘材料的柔韧性试验方法

标准号：ANSI/ASTM D6272-2000
中文标准名称：利用四点结合法进行非增强和增强塑料及电气绝缘材料的柔韧性试验方法
英文标准名称：Test Method for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials by Four-Point Bending
标准类型：K15;G31
发布日期：1999/12/31 12:00:00
实施日期：2000/9/12 12:00:00
中国标准分类号：K15;G31
国际标准分类号：83.080.01;29.035.20
适用范围：This test method covers the determination of flexural properties of unreinforced and reinforced plastics, including high-modulus composites and electrical insulating materials in the form of rectangular bars molded directly or cut from sheets, plates, or molded shapes. These test methods are generally applicable to rigid and semirigid materials. However, flexural strength cannot be determined for those materials that do not break or that do not fail in the outer fibers. This test method utilizes a four point loading system applied to a simply supported beam. This test method may be used with two procedures: Procedure A, designed principally for materials that break at comparatively small deflections. Procedure B, designed particularly for those materials that undergo large deflections during testing. Procedure A shall be used for measurement of flexural properties, particularly flexural modulus, unless the material specification states otherwise. Procedure B may be used for measurement of flexural strength. Comparative tests may be run according to either procedure, provided that the procedure is found satisfactory for the material being tested. The values stated in SI units are to be regarded as the standard. The values provided in parentheses are for information only. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1 -This test method is equivalent to, but not identical to ISO 14125 (Method B).