ISO 10816-2-2009 机械振动.通过在非旋转部件上的测量评价机械振动.第2部分:功率超过50MW,额定转速为1500 r/min、1800 r/min、3000 r/min 和 3600

标准号：ISO 10816-2-2009
中文标准名称：机械振动.通过在非旋转部件上的测量评价机械振动.第2部分:功率超过50MW,额定转速为1500 r/min、1800 r/min、3000 r/min 和 3600 r/min的地面安装的蒸汽轮机和发电机组
英文标准名称：Mechanical vibration - Evaluation of machine vibration by measurements on non-rotating parts - Part 2: Land-based steam turbines and generators in excess of 50 MW with normal operating speeds of 1500 r/min, 1800 r/min, 3000 r/min and 3600 r/min
标准类型：J04;Z32
发布日期：1999/12/31 12:00:00
实施日期：1999/12/31 12:00:00
中国标准分类号：J04;Z32
国际标准分类号：17.160;27.040
引用标准：ISO 7919-2;ISO 10816-1-1995
适用范围：This part of ISO 10816 establishes provisions for evaluating the severity of in-situ, broad-band vibrationmeasured radial (i.e. transverse) to the shaft axis on all main bearing housings or pedestals and in the axialdirection on thrust bearings. These are in terms of:⎯ vibration under normal steady-state operating conditions;⎯ vibration during other (non-steady-state) conditions when transient changes are taking place, includingrun up or run down, initial loading and load changes;⎯ changes in vibration which can occur during normal steady-state operation.This part of ISO 10816 is applicable to land-based steam turbines and generators with power outputs greaterthan 50 MW and a normal operating speed of 1 500 r/min, 1 800 r/min, 3 000 r/min or 3 600 r/min. It is alsoapplicable to steam turbines and/or generators which are directly coupled to a gas turbine (such as forcombined-cycle applications). In such cases, the criteria of this part of ISO 10816 apply only to the steamturbine and the generator (including synchronizing clutches). ISO 7919-4 and ISO 10816-4 are applicable tothe evaluation of the gas turbine vibration.The evaluation criteria in this part of ISO 10816 are not applicable to the electromagnetic excited vibration withtwice line frequency at the generator stator core and housing.The numerical values specified are not intended to serve as the only basis for judging the severity of vibration.For large steam turbines and generators, it is also common to judge the vibration based on measurements takenon the rotating shafts. For such vibration measurement requirements, see ISO 7919-1 and ISO 7919-2.