BS EN 61967-2-2005 集成电路.150kHz～1GHz电磁辐射的测量.第2部分:辐射释放的测量.TEM辐射室和宽频带TEM辐射室法

标准号：BS EN 61967-2-2005
中文标准名称：集成电路.150kHz～1GHz电磁辐射的测量.第2部分:辐射释放的测量.TEM辐射室和宽频带TEM辐射室法
英文标准名称：Integrated circuits - Measurement of electromagnetic emissions, 150 kHz to 1 GHz - Part 2: Measurement of radiated emissions - TEM cell and wideband TEM cell method
标准类型：L56
发布日期：2006/1/23 12:00:00
实施日期：2006/1/23 12:00:00
中国标准分类号：L56
国际标准分类号：31.200;33.100.20
引用标准：IEC 60050-131-2002;IEC 60050-161-1990;IEC 61967-1
适用范围：This test procedure defines a method for measuring the electromagnetic radiation from an integrated circuit (IC). The IC being evaluated is mounted on an IC test printed circuit board (PCB) that is clamped to a mating port (referred to as a wall port) cut in the top or bottom of a transverse electromagnetic (TEM) or wideband gigahertz TEM (GTEM) cell. The test board is not inside the cell, as in the conventional usage, but becomes a part of the cell wall. This method is applicable to any TEM or GTEM cell modified to incorporate the wall port; however, the measured radio frequency (RF) voltage will be affected by many factors. The primary factor affecting the measured RF voltage is the septum to IC test board (cell wall) spacing.This procedure was developed using a 1 GHz TEM cell with a septum to floor spacing of 45 mm and a GTEM cell with average septum to floor spacing of 45 mm over the port area.Other cells may not produce identical spectral output but may be used for comparative measurements, subject to their frequency and sensitivity limitations. A conversion factor may allow comparisons between data measured on TEM or GTEM cells with different septum to floor spacing.The IC test board controls the geometry and orientation of the operating IC relative to the cell and eliminates any connecting leads within the cell (these are on the backside of the board, which is outside the cell). For the TEM cell, one of the 50 Ω ports is terminated with a 50 Ω load. The other 50 Ω port for a TEM cell, or the single 50 Ω port for a GTEM cell, is connected to the input of a spectrum analyser or receiver that measures the RF emissions emanating from the integrated circuit and impressed onto the septum of the cell.