IEC 61290-10-2-2007 光纤放大器.试验方法.第10-2部分:多通道参数.使用选通光频谱分析仪的脉冲法

标准号：IEC 61290-10-2-2007
中文标准名称：光纤放大器.试验方法.第10-2部分:多通道参数.使用选通光频谱分析仪的脉冲法
英文标准名称：Optical amplifiers - Test methods - Part 10-2: Multichannel parameters - Pulse method using a gated optical spectrum analyzer
标准类型：M33
发布日期：1999/12/31 12:00:00
实施日期：1999/12/31 12:00:00
中国标准分类号：M33
国际标准分类号：33.180.30
引用标准：IEC 61291-1
适用范围：This part of IEC 61290 applies to optical fibre amplifiers(OFA)using active fibres，containing rare-earth dopants currently commercially avallable．The object of this lnternational Standard is to establish uniform requirements for accurate and reliable measurements of the signal-spontaneous noise figure as defined in IEC 61291—1．The test method independently detects amplified signal power and amplified spontaneous emission(ASE)power by launching optical pulses into the OFA under test．The ASE level is measured by synchronously measuring the power on an optical spectrum analyzer(OSA)during the optical pulse off period．The average optical signal level is measured by random sampling in the OSA．Such measurement is possible because the gain response of the rare—earth doped OFA is relatively slow．particularly in Er—doped OFA．However，since the OFA gain dynamics vary with amplifier types，operating conditions，and control schemes，the gain dynamics should be carefully Considered when applying the present test method to va rious OFA．The manufacturer of the OFA should present data validating the required modulation frequency to limit the error to<1 dB．The measurements for obtaining this information are described in Annex A．Two alternatives for determining the signal—spontaneous noise figure are specified；namely，the optical switching technique and the gated-OSA technique．The procedure described in this standard is the gated—OSA technique．The optical switching technIqMe is described in IEC 61290-10-1．The test method described is，in general，for multichannel applications．Single-channel applications are a special case of multichannel applications NOTE All numerical values followed by are suggested values for which the measurement is assured．Other values may be acceptable but should be verified．