ANSI/ASTM D4097-2001 接触制模纤维玻璃增强的热固树脂耐腐蚀罐用规范

标准号：ANSI/ASTM D4097-2001
中文标准名称：接触制模纤维玻璃增强的热固树脂耐腐蚀罐用规范
英文标准名称：Specification for Contact-Molded Glass-Fiber-Reinforced Thermoset Resin Corrosion-Resistant Tanks
标准类型：G33
发布日期：1999/12/31 12:00:00
实施日期：2001/6/10 12:00:00
中国标准分类号：G33
国际标准分类号：23.020.10
适用范围：This specification covers cylindrical tanks fabricated by contact molding for above-ground vertical installation, to contain aggressive chemicals at essentially atmospheric pressure, and made of a commercial-grade polyester or vinyl ester, resin. Included are requirements for materials, properties, design, construction, dimensions, tolerances, workmanship, and appearance. This specification does not cover the design of vessels intended for pressure above hydrostatic, vacuum conditions, except as classified herein, or vessels intended for use with liquids heated above their flash points. The values given in parentheses are provided for information purposes only. Special design consideration should be given to vessels subject to superimposed mechanical forces, such as earthquakes, wind load, or agitation, to vessels subject to service temperature in excess of 180?F (82?C), and to vessels with unsupported bottoms. Note 2 -There is no similar or equivalent ISO standard. The following safety hazards caveat pertains only to the test method portion, Section 11, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.