ANSI/ASTM D4703-2000 热塑模压试样、饰板或薄板后试样的切削、冲压或机械加工惯例

标准号：ANSI/ASTM D4703-2000
中文标准名称：热塑模压试样、饰板或薄板后试样的切削、冲压或机械加工惯例
英文标准名称：Practice for Compression Molding Thermoplastics into Test Specimens and Plaques or Sheets from which Specimens will be Cut, Stamped or Machined
标准类型：G31
发布日期：1999/12/31 12:00:00
实施日期：2000/12/10 12:00:00
中国标准分类号：G31
国际标准分类号：83.080.20
适用范围：This practice covers the compression molding of thermoplastic granules and milled stock for the preparation of test specimens. While conditions for certain materials are given, the primary source of specific conditions shall be the material specification standards for each type of material. The values stated in SI units are to be regarded as the standard. The values given in brackets are for information only. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1The main body of this practice is equivalent to ISO 293-1986. and ISO 293-1986 differ in some details; however, specimens prepared using , Procedure A should be equivalent to those prepared using ISO 293-1986, Cooling Method D. Specimens prepared using , Procedure C should be equivalent to those prepared using ISO 293-1986, Cooling Method B. However, due to the greater cooling rate tolerances of the ISO standard, specimens prepared in accordance with ISO Cooling Method B may not be equivalent to , Procedure C.