ANSI/ASTM D1708-1997 用微型抗拉试样测试塑料抗拉特性的方法

标准号：ANSI/ASTM D1708-1997
中文标准名称：用微型抗拉试样测试塑料抗拉特性的方法
英文标准名称：Test Method for Tensile Properties of Plastics by Use of Microtensile Specimens
标准类型：G31
发布日期：1999/12/31 12:00:00
实施日期：1997/3/5 12:00:00
中国标准分类号：G31
国际标准分类号：83.080.01
适用范围： This test method covers certain material specifications for which a history of data has been obtained using the standard microtensile specimen. The specimen geometry has been changed to be equivalent to that of ISO 12086-2:1955. In general, this test method is superseded for general use by either Test Methods D 882 or Test Method D 638. The very small Type V specimen in Test Method D 638 is the recommended specimen when limited amounts of material are available. This test method covers the determination of the comparative tensile strength and elongation properties of plastics in the form of standard microtensile test specimens when tested under defined conditions of pretreatment, temperature, humidity, and testing machine speed. It can be used for specimens of any thickness up to 3.2 mm [1/8 in.], including thin films. This test method cannot be used for the determination of modulus of elasticity. For the determination of modulus, see Test Method D 638 or Test Methods D 882. Test data obtained by this test method are relevant and appropriate for use in engineering design. The values stated in SI units are to be regarded as standard. The values given in brackets are for information only. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.There is no equivalent or similar ISO standard.